bigdaddyg8
- 591
- 93
i have been using mycostop from start to battle any issues that might arise. no such thing as sterile? i have everything under control. just sick of buying fucken expensive shit that i have to battle with and turns to shit before the jug is finished. i am going to try to switch over from CC to Veg+Bloom my next change out at week 7 out of a ten week strain jesus OG.If your having a mold mildew issues, check out Procidic2 it'll solve all your problems with that.
i am going use HD as a base? the water coming out of my tap is 160ppm/500scale .do you think switching base nutrients and using either ro water or tap water ect. is it possible perhaps it may help control the sway?I used the RO/Soft V+B last run
I cut the RO with well water to 100ppm and mixes up to 1.0ec range right around 5.9pH
I figured out you can control the swing by adjusting the hardness of your water, anything over 100ppm and I get a slow rise, anything less than 75ppm and you gotta watch the acid buffers in the V+B driving the pH down.
Are you currently using any Calmag supplement? Look at the V+B numbers, they got Ca and Mg beefed up pretty good so you might watn to consider that.
This was my experience. I also noticed all the cuts I ran again with V+B after switching from GH CocoTek were frostier, healthier and better looking.
thats what we have to do try different things! hopefully i can figure it out?I had to try different ppms of my starting water until i got the right thing happening for my setup
upon further review you was absolutely right i should be using RO/soft!I used the RO/Soft V+B last run
I cut the RO with well water to 100ppm and mixes up to 1.0ec range right around 5.9pH
I figured out you can control the swing by adjusting the hardness of your water, anything over 100ppm and I get a slow rise, anything less than 75ppm and you gotta watch the acid buffers in the V+B driving the pH down.
Are you currently using any Calmag supplement? Look at the V+B numbers, they got Ca and Mg beefed up pretty good so you might watn to consider that.
This was my experience. I also noticed all the cuts I ran again with V+B after switching from GH CocoTek were frostier, healthier and better looking.
thanks for the link !I dont run a res so I cant really give you any pointers there but this stuff is easy to use, for sure.
have you been here yet?
https://www.thcfarmer.com/community...search-user-thread.75909/page-40#post-2111102
@PhatNuggz can you post a link of your thread? I'm using EH 2 part with great success but am switching over the Veg Bloom at the moment
im on my 3rd and 4th runs of vb/ro soft.i love it
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?