LEDhead
- 704
- 43
No lockout issues? I’m concerned the amount available will lock out not just Calcium but others. There’s gotta be a reason why others are so low in %, but yeah I’ve been debating getting that also.Go for the Agsil 16h.. i havent looked back since.
No lockout issues? I’m concerned the amount available will lock out not just Calcium but others. There’s gotta be a reason why others are so low in %, but yeah I’ve been debating getting that also.
No lockout issues? I’m concerned the amount available will lock out not just Calcium but others. There’s gotta be a reason why others are so low in %, but yeah I’ve been debating getting that also.
I’m using Armor Si with Jacks 3-2-1 and CALiMAGic in coco. Wanted to trade out the armor Si for Power Si Bloom since I’m still early in flower (day 6) but not sure how much to use. My nutrients are at a 2.2ec 1098ppm and what I’ve read people are dropping there ppm’s a bit to avoid burn. I’m using 2.5ml of armor si per gallon now. So o guess my question is has anyone changed out these and if so what was the ratio used? Thanks for any help, here’s some pics of my current scrog
Also like to mention on this it has to do with saturation when mixing concentrates. You can only dilute so much Pot Silica into water to make a concentrate w/o it precipitating out of the solution or for long term storage. Why dry is usually better then liquids.
That ones as needed so I add the lowest amount 1.25ml per gallon just for the extra cal mag but cutting it out after this weekAlso looking back at this thread, you mentioned you are using calimagic on top of your jacks 321. If i remember correctly, part B is your calcium nitrate, and your 1( magnesium sulfate) is your mag. No need to use cali magic, your 321 already has what you need.
That ones as needed so I add the lowest amount 1.25ml per gallon just for the extra cal mag but cutting it out after this week
Great question, you should message PowerSi on IG and post your results here.Reading the ingredients of Power SI is says Potassium Silicate and Phosphoric Acid primarily? IS it possible when starting a Reservoir Change that adding GH PH down and your Liquid Potassium Silicate first is actually producing Silicic Acid? Or is there some fancy Lab work I am missing here? In other words, question: Does combing Potassium Silicate and Phosphoric Acid produce Silicic Acid in any quantity?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?