Thanks Bill for this link.I haven’t been on their site for a while and wasn’t aware they had these different lineups.I run jacks on a .67 scale using it with calnit and epsom salt.I am wondering if I should add their pk booster,as I don’t use any atm.
Ok i did some reading and correct they dont cool the bulb.
BUT nonetheless why go DE and put glass in between blocking some spectrum/light and eventually hurting yield?.Idk to me it makes no sense unless the op is growing in a tent which again it makes no sense getting DE imho.
If it was me with...
Did you buy the AC reflectors?
If you did i would rock em open glassed.
But you’re going to need 5k btu of cooling for each so that puts you at 9.6 lights per 48k btu ac.
On the other hand i would look for the 600/750 gavitas as people run em in shorter ceiling grows.From my understanding they...
Bump...
If using a Grundfos MQ-45 Pump is there a need for an accumulator if your set up is zoned properly??.Meaning it’s split thru different zones using solenoids and octabbublers??.
I like changing up grows at times and i ‘d hate not to have the right accumulator when i change pot sizes and...
It’s possible,i run 2 rows of adjustawings with 3 rows of plants under them.The middle row where the they’re right under the wings edge seemed the most effected.I say that because the brightest area comes from the edge of the reflector.It’s possible that with co2 and too much light effected...
No they were vegged in a separate room.
But they’ve been also vegging in the flower room for about a month.But my previous 3 runs i’ve vegged them in the same room iam having issues with.
The flame was blue,but i would smell a faint of gas while it fired up but it went away.I do have a good amount of foam insulation and some pvc manifold for a drip system that iam still working on.I also have some reflective panels,and rolls.I have panda film 36 feet across covering on side on a...