DUDE!! I've seen professionals grows an never seen none this bushy! Not 1 no offense to no one but Man She's a short monster!
OK so I can give a little advice on the clone sitch but you will have to act fast! I'm no clone master myself but I have had a low success (being I only had one large mother ) if I had all materials first I would master it I have managed to get one to root but still struggling.But you on other hand my friend could give her a really nice haircut an experiment as much as you want she's almost too bushy if you don't clone top an trim now you will maybe have to graft her or build some type of screen to get more light throughout the whole plant thus creating more bud sites. This would still require cutting toping an trimming otherwise you about to have a extra large headache! So you should Trim her asap to stress her just enough to make her grow vertically. You wanna do most trimming cloning topping etc very early especially to clone otherwise you will struggle like me (trying to clone 4-6 weeks into flower). When cutting make sure to b sterile and very clean don't risk anything. You can clone any part of the plant including leaves but they won't do thing but grow roots.(do not clone leaves) You wanna clip a clones straight from the main cola to increase success rate but clipping at any node will do just fine. There's many ways to go about clipping and cutting. You should take your time and binge on info on clones and topping and gather all supplies to create a very good atmosphere for clones. You want it to b warm though it doesn't necessarily has to be it just works well with the starting process. You want warm humid and very very low light...low light will encourage root formation. The light you have on your mother is wayyy toooo too far strong for a clone. Get you a couple small wattage CFLs some LEDs are even too strong. Get you some starting trays since you have an abundance of clone opportunities. You want a media such as peat coco rockwool etc. and you will need some kinda root hormone gel or powder doesn't matter but it is very much needed or else its 10x harder trust me. If you buy the starter plant tray (usually could at any major garden store) try and find a cheap cake pan or something similar with a clear top to place all your clones under to keep the humidity. Get you a heating also and place under the tray or trays and mist the lid or what have you at least once a day to keep it humid. Now back to the cutting part. I say you should cut from main cola(from bottom to the top)because the would have been first to die off due to lack of light and it easier to get a good clean cut, close to the main stem...after cutting immediately place in water. NOW LISTEN VERY IMPORTANT IVE COME TO REALISE I HAD BEEN DOING WRONG.While your clipping in water, make your 45degree angled cut while under water. This blocks air and keeps the clone heathy. It is RECOMMENDED you do this with EVERY CUTTING ESPECIALLY CLONES. Your clones need to be at least 2-3in and should be cut under water quickly dipped in hormone and straight to your light media. Make sure to keep your cloning hormone sterile by not dipping straight into the original container, use a separate dry cleaned and sterile container to dip your clones in. You can sterile with 1part bleach to 10 part water 1part h2o2_ to 8 part water or rubbing or isopropyl alcohol. I'll try an find some pics of cloning and topping.