what Ppm for my current plant stage?

[FlyingW]

I've got two clones that were about 3 weeks old when I introduced thim to my dwc system. They have been in the system for 1week and are doing okay, a small amount of yellowing. Wanting help with ppm of nutrients for this stage, I've read anywhere from 550 to 1000? Thanks for the help.

 

[ru knuts]

Don't rely on my opinion, but I think your ppm is quite high for 3 weeks, but I'm doing ebb and flow, so I may be way off base here. I was at 550 at that time.

 

[Nugg]

Right..I'm only 3 yrs.into dwc..but..i never exceed 650-700..any higher they start to show burn.. even if I try to ease them into more....I go by size of my plants...3 weeks past a rooted clone... guessing..250-300..

 

[newbie12345]

I've got two clones that were about 3 weeks old when I introduced thim to my dwc system. They have been in the system for 1week and are doing okay, a small amount of yellowing. Wanting help with ppm of nutrients for this stage, I've read anywhere from 550 to 1000? Thanks for the help.

should only be at about 250ppm

 

[AnselAdams]

I've got two clones that were about 3 weeks old when I introduced thim to my dwc system. They have been in the system for 1week and are doing okay, a small amount of yellowing. Wanting help with ppm of nutrients for this stage, I've read anywhere from 550 to 1000? Thanks for the help.

First; Welcome to The Farm

Now with regards to the ppm. Yes the range is resonable, however the age of your cuttings suggest that a ppm of 250-300 would be about right. I don't get to 550 until around week 3 after germ/sprout week (four weeks from germ). I am not an oracle, I am growing autos which are fairly predictable. If you are growing photos i am pretty sure the same applies, but I will leave it to one of the photo folks to say yes or no.

Happy Farming