ogplatinum
- 1,188
- 63
So today i picked up a glass piece to make BHO and a can of vector. First crack at it and with some tips from Crom I think I did a fine job...accept for slicing into my left thumb about .25 inchs with a straight razor making this really hard to type lol. I was to ancy while scraping lol!
So heres what i did...
30-35g's of bottom buds and sugary shake from my mentor grower and family member...Strain=Sour Goo (Sour D x Afgoo)
Chopped to a nice and fluffy texture, not to fine.
Fill glass piece.
Used some 120micron metal screen and 2 coffee filters for filtration.
Run that thane through there (think i might even get another can tomorrow and run it again, looks to still be some trichs n there!
Got my JUST boiling water for the first purge...After all butane is ran through I let it sit outside for a good ten mins while the oven is pre heating to 160-170 degrees.
Put the tray after all larger bubbles are popped in the oven for 10 mins...
After the 10 mins is up I put the pyrex on a skillet set at 200 degrees and began to whip the oil and get all the access butane out, after about 10 mins of whippin, let sit again and scrape!
It balled up into a nice semi malleable state, very stringy and sticky!
Smells like the material used with a lil more hashyness.
Feedback? This shit is strong too!
The pics go step by step, well sort of lol. Most of the inside purging isn't pictured, sorry guys.
Lemme know what you think, just got this BHO rig and i figure this will be the first of many runs!!! Good solid piece too for only 40!
So heres what i did...
30-35g's of bottom buds and sugary shake from my mentor grower and family member...Strain=Sour Goo (Sour D x Afgoo)
Chopped to a nice and fluffy texture, not to fine.
Fill glass piece.
Used some 120micron metal screen and 2 coffee filters for filtration.
Run that thane through there (think i might even get another can tomorrow and run it again, looks to still be some trichs n there!
Got my JUST boiling water for the first purge...After all butane is ran through I let it sit outside for a good ten mins while the oven is pre heating to 160-170 degrees.
Put the tray after all larger bubbles are popped in the oven for 10 mins...
After the 10 mins is up I put the pyrex on a skillet set at 200 degrees and began to whip the oil and get all the access butane out, after about 10 mins of whippin, let sit again and scrape!
It balled up into a nice semi malleable state, very stringy and sticky!
Smells like the material used with a lil more hashyness.
Feedback? This shit is strong too!
The pics go step by step, well sort of lol. Most of the inside purging isn't pictured, sorry guys.
Lemme know what you think, just got this BHO rig and i figure this will be the first of many runs!!! Good solid piece too for only 40!