P
Pimpernickel
- 36
- 8
I'm not having much luck getting my bulkheads to seal. I made sure the surfaces were clean and jiggle the pipe back and forth trying to get a little more turn on the nut but some are still leaking. Any tips?
still having troubles bro? I've had my share of leaks and my system being on a wood floor that is not very level or is warped in some spots from leakage i've had to put little shims on one side of module to get them level also i've noticed if your system isn't square your going to have problems.Make sure your manifolds are the same distance apart in front vs back.Hope you got it worked out
I'm not having much luck getting my bulkheads to seal. I made sure the surfaces were clean and jiggle the pipe back and forth trying to get a little more turn on the nut but some are still leaking. Any tips?
Gosh we have those pliers sitting right there for our cap where we empty the system and never even thought to use em on the bulk heads. Good idea duh.:rolleyes:Big ChannelLock (water pump pliers) 460 or 480 models are for 2 and 3 inch. They are a life saver
I have an extra bucket just in case i kick that sucker.I've had a few problems but turned out the bucket was cracked on the seam and over tightening is def a no no start hand tight and then only go a quarter turn after that I made a wrench out of a water filter wrench just modified it with a grinder wheel works great
I have two lolI have an extra bucket just in case i kick that sucker.
any o-ring leaks or glue leaks
got extra 8 and 13 just in case/why not/I have an extra bucket just in case i kick that sucker.
any o-ring leaks or glue leaks