$9 DIY BHO tube, stainless, legs

[Str8Dank]

lead i dont know yet to be honest bro i only ran it once and tha twas finger tight. i just assumed pliers would get it tight enough. i guess i'll find out tonight!

 

[leadsled]

lead i dont know yet to be honest bro i only ran it once and tha twas finger tight. i just assumed pliers would get it tight enough. i guess i'll find out tonight!

Wanted to give a heads up. Maybe have a clean rag ready. I wore thick gloves and then covered the leak with my finger. :)

 

[Str8Dank]

oh yeah thanks man i was gonna have a rag around because the first run leaked some. hopefully it gets close to sealed with the vice grips closing it.

now the main issue is how the hell to get the old bud out of it lol. it was a real pain to clean it out.

 

[leadsled]

oh yeah thanks man i was gonna have a rag around because the first run leaked some. hopefully it gets close to sealed with the vice grips closing it.

now the main issue is how the hell to get the old bud out of it lol. it was a real pain to clean it out.

clean it out right after much easier.

I use a flat head screw driver. pry it out then start stabbing the material to break it free.
then follow up with the brush that came with the baster!

 

[mal]

Vector Butane

Vector butane comes with several sizes of tips for injecting the butane, you need the proper size for the baster. With the proper fit between the needle hole(hole where you pulled the needle out of the baster) and the butane tip there will be no leaks from that end. As far as cleaning out for next run use a cork screw first, screw in and pull out then a shishkabob skewer from the needle end will get the rest. If you have the right tip on your butane you only need the needle tip hand tight, unscrew after run to aid in cleanout then simply hand tighten



mal

 

[Str8Dank]

thanks!!!!!