2Bad
- 3,418
- 263
I know people say to make one but If I did that I'd need a hand written guide to do it . So any put together ones on sale ?
The micron bag you use depends on moisture of the bud.Hey steam can you explain what I need for the nugsmasher thinking of getting the mini but you tell me . I’m a noob . I know nothing about what size micron or what tools I need to press. 12 hours left on the sale
Sounds good mane I think I’m going to wait until 420 sale , I won’t have anything to press until then anyyways hahaThe micron bag you use depends on moisture of the bud.
I find I use the smaller micron bags more. The dryer the bud the smaller the micron. I press cured weed.
Size should fit in the plates with room to spare so 7grams may even be too big for the mini?
I don't press more than 7 at a time just to be able to keep track. Some don't use bags at all.
I don't pre press or have any other fancy equipment. I do use the bags and fold the corners as shown in video to have flat bottom.
I cool the parchment or silicone on frozen meat or a baking sheet in freezer after extraction.
Silicone mats can be found at grocery stores. Look for the ones that are reenforced.
The press is the easiest and fastest way to extract.
Once the plates are warmed up you are 10 minutes start to finish.
@Moshmen whatcha got there? All same temp & diff strain? The Different consistencies caught my eyeI bought the press used and the plates and controller on sale I got less than $350 into my rig not big enuff for smashing pounds but an ounce I can tolerate
I don’t use bags - just gotta clean the nail more oftenThe micron bag you use depends on moisture of the bud.
I find I use the smaller micron bags more. The dryer the bud the smaller the micron. I press cured weed.
Size should fit in the plates with room to spare so 7grams may even be too big for the mini?
I don't press more than 7 at a time just to be able to keep track. Some don't use bags at all.
I don't pre press or have any other fancy equipment. I do use the bags and fold the corners as shown in video to have flat bottom.
I cool the parchment or silicone on frozen meat or a baking sheet in freezer after extraction.
Silicone mats can be found at grocery stores. Look for the ones that are reenforced.
The press is the easiest and fastest way to extract.
Once the plates are warmed up you are 10 minutes start to finish.
Yes I run a couple of test presses before I decide what I want - those are different strains all at my base of about a 1 to 1 1/2 gram bud no prepress plates set at 190- let bud warm up for 20 sec ish smashed but not under pressure then I slowly consistently press till pressure is achieved I start at about 2500 lbs but it’s an art! Lol then watch flow when it stops I release usually less than 1 minute - total time for test is around 2 minutes - I’ll make adjustments till I get what I want from each strain then do quantity@Moshmen whatcha got there? All same temp & diff strain? The Different consistencies caught my eye