tonyOmerta
- 10
- 3
Hello, I have been browsing these forums for some time now but have not been able to find a solution to my shatter issue as of yet so I created an account here at THCfarmer in hopes of finding someone who can help me out. I have six ounces of BHO that was blasted and never purged completely by a friend and I am attempting to turn it into shatter with little to no success. The batch was made from fresh trim and came out a nice light yellow but very waxy. So far I have winterized the entire batch with Everclear at a ratio of 800 ML / per Oz of BHO.
Yesterday I attempted to get one oz to shatter up. First I split it in two 14gram batches. Then I put one 14g patty in a vac chamber I made at home and placed that on top of a nuwave2 induction cooker. After straining the waxes and lipids from the bho I poured the dewaxed solution into a pyrex dish which I sat on top of a pan that was on my nuwave. I heated the nuwave up and used an IR gun to make sure the everclear never went over 105 degrees or under 88 degrees. When the everclear was all evaporated out I scraped it up with a razor, put it on parchment paper and threw it in the vac chamber. After this point is where i think I am ruining the batch. I slowly heat the patty up until it starts to really bubble up and turn liquid then I turn on my vacuum and lowered the heat to 115. I left it on vac and at 115 degrees for about 12 hours and when I checked in the morning only the edges of the patty resembled anything close to shatter. The vast majority of the patty was just clear sticky messy oil and I cannot get it to harden no matter how much I experiment with it. I am afraid of ruining the other few ounces I have. Can anybody offer me some advice as to how to make this stuff stable? I would even be willing to pay money for a good set of directions as long as the person who provides them is a good reputable memeber of the community.
Yesterday I attempted to get one oz to shatter up. First I split it in two 14gram batches. Then I put one 14g patty in a vac chamber I made at home and placed that on top of a nuwave2 induction cooker. After straining the waxes and lipids from the bho I poured the dewaxed solution into a pyrex dish which I sat on top of a pan that was on my nuwave. I heated the nuwave up and used an IR gun to make sure the everclear never went over 105 degrees or under 88 degrees. When the everclear was all evaporated out I scraped it up with a razor, put it on parchment paper and threw it in the vac chamber. After this point is where i think I am ruining the batch. I slowly heat the patty up until it starts to really bubble up and turn liquid then I turn on my vacuum and lowered the heat to 115. I left it on vac and at 115 degrees for about 12 hours and when I checked in the morning only the edges of the patty resembled anything close to shatter. The vast majority of the patty was just clear sticky messy oil and I cannot get it to harden no matter how much I experiment with it. I am afraid of ruining the other few ounces I have. Can anybody offer me some advice as to how to make this stuff stable? I would even be willing to pay money for a good set of directions as long as the person who provides them is a good reputable memeber of the community.