MischiefGrows
- 95
- 33
I just finished my second round with Canna A/B for coco. They were both very good grows without any deficiencies or burning or any stress at all really. I aim for a 2.5 week flush but some of the strains ended up taking longer than i thought so some even got closer to a 3.5 week flush. However, even with up to 25 days with only plain water, my joints are still burning off a dark black ash with very little to no grey in it. It comes out looking like top shelf meds and the flavor is there and its not harsh at all ( but I know there could be more flavor and it could even be a little smoother). I want my ashes to fall off as white powder and I'm getting the very opposite- it's driving me crazy. I do a feed, feed, water. I start flowering with my ppm's at about 900 and bump up to 1250 or so and then back down after week 5 or so. I use tap water that has a starting ppm of about 50-100 depending on the time of year (i have considered this to be the source of my troubles but no one else seems to think that low of ppm's from tap would cause problems). Other products that i use:botanicare calmag- in flowering i use this at a ration of 2 parts calmag to 3 parts AB for the first 2 weeks. Then i drop it to 1 part CM to 2 parts AB (ex. 5 ML CM to 10 ML of A and B.)PK 13/14- I use this on the middle week, for an 8 weeker i use it on week 4 and for a 10 weeker i use it on week 5. I use it for only one week. Two times in that week @ 6 ML/gallon. I have also considered this a source of causing problems. My plants always seem to like it just fine but perhaps i should start with a lower dose? I would imagine if i was locking out nutrients from my plant, i would be able to tell by the way my plants look first, right? not from ashes 6 weeks later after its dried and cured.Carboload- i use this pretty much up until flush at 6 ML/gallon.Sugaree- I just use this for the last few weeks before flush at 6 ML/gallon.Clearex- Used the first few flushes at 10 ML/gallon.That's it. No weird sprays or any sprays or pesticides at all in flowering. I used botanicare pro previously and never had problems with my ashes burning black like i am with canna. Any help?