Wolters_88
- 115
- 28
I have both vents open and four fans going including a tower fan. Anything else I could do?Well they are later in flower and prob not transpiring as much but it could be they need more air movement
I have both vents open and four fans going including a tower fan. Anything else I could do?Well they are later in flower and prob not transpiring as much but it could be they need more air movement
I would just use plain tap as is. The ph is usually higher so just tend adjust and feed.Also, when I’m flushing do I need to use PH’d RO or can I just run like ten gallons of water through and then do the last five five with PH’d and RO water?
The maximum amount of chloramine is 4ppm under regulations. Most water supplies are 1 ppm. Ascorbic acid will neutralize it if you really worried about it. I wouldn't be. Water your plant in the garden?
Ok, thanks. Can I foliar feed calmag during flower? Will it burn them..etc?The maximum amount of chloramine is 4ppm under regulations. .oat water supplies are 1 ppm. Ascorbic acid will neutralize it if you really worried about it. I wouldn't be. Water your plant in the garden?
Should be fine to run with your hlg 600 photo period.
Personally I avoid foliar feeding. The only reason really is to get nutrients into the plant fast. So like treating a deficiency or an infection like PM. Other than that I would avoid it as a new grower.Ok, thanks. Can I foliar feed calmag during flower? Will it burn them..etc?
Personally I avoid foliar feeding. The only reason really is to get nutrients into the plant fast. So like treating a deficiency or an infection like PM. Other than that I would avoid it as a new grower.
Ok what nutes again and what ratios. Just because you see calcium deficiency does mean there is not enough calcium there can be many reasons and most of the time its a nutrient ratio issue or transpiration issue when you see a calcium deficiency.I am flushing the plants and nothing seems to be stopping this. This is my third grow and it’s the same issue every single time. Always a calcium issue. I ph to 5.8. I’m feeding 550-600 ppm. But every single grow... calcium. Only thing I can think of to get calcium in there fast would be a foliar spray. It’s now on all six of my plants and I have flushed the first plant twice at this point.
Yeahthose got way over fed at some point. That looks a lot more like a lockout than a deficiency IMO.