4
4.D.
- 57
- 0
I just set up my buddy with a DIY undercurrent in those bids, The 3 uni-seals are insane to put in and everyone leaked. check out 3in conduit, I would use that next run like ghettogro did if we ever re-do it
Wow, that's lots of leaking ?Uni's.
Guess they must have the midas touch at CC or growers would be lining up to lay the smack down if UC's leaked like that. I thinks its all about the hole quality IMO.
But when/if in doubt I'd opt for bulkheads....though it seems it would cost far less to just figure out how to make your uni's work.
BTW, have fun trying to wrestle that 6" PVC into the seals....please take video as I'm sure we'd all love to see you pull that one off. ;)
I built a diy for a friend. No leaks at all. Ucmenow is right its all about hole quality. Use a deburing tool to clean each hole you cut to smooth the edges. Are you going to be using uniseals or grommets? The tougher the fit the less likely it will leak use a little smaller than recommended hole saw. Its a pain to get the pvc in, but no leaks at least :)
8 x 3 will kill it
but 6 x 4 will do way better
I built a diy for a friend. No leaks at all. Ucmenow is right its all about hole quality. Use a deburing tool to clean each hole you cut to smooth the edges. Are you going to be using uniseals or grommets? The tougher the fit the less likely it will leak use a little smaller than recommended hole saw. Its a pain to get the pvc in, but no leaks at least :)
Looking good!!
Are you guys gonna paint or use a poly wrap?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?