freezeland2 said:

I am planning to up pot, take some cuttings, and then start flowering. I have a 3x3 in a different room that I am planning to run a few clones in. The humidity is very low here and that is going to be my challenge running clones.

I had two misters running on my grow and I was able to get down to one now I am preparing to flower. I moved the mister to the room where the tent is. Best I can get to with it so far is 50%. My question is will that ez clone machine running raise rh in the tent? I am hoping so. It’s still in the box and I plan to do a test but hoping someone can set my expectations. If I need another mister I want to find out now.

Click to expand...

Backyard_Boogie said:

I have an EZ cloner and they are amazing work fantastic! Unfortunately for you the system does NOT raise humidity in the grow space. Maybe a tiny bit but not enough to really mitigate your humidity issue. This is actually better because the system is closed and it helps prevent excess evaporation this means you don't have to be filling it up with water everyday. It stays full for a good long time before you need to cap it off. If I were you I would buy these cheap items and put them inside your tent...

https://www.amazon.com/Humidity-Controller-Inkbird-Humidistat-Pre-wired/dp/B01J1E5LWM/ref=sr_1_1_sspa?crid=1L7CSCZ2G78EI&keywords=inkbird+humidity+controller&qid=1643928167&sprefix=inkbird+humidity+,aps,170&sr=8-1-spons&psc=1&smid=A197YPAPAP8V04&spLa=ZW5jcnlwdGVkUXVhbGlmaWVyPUEzTkhOTjFFR1dCQjRQJmVuY3J5cHRlZElkPUEwNzg4ODUzT0laT0hLOFlTVTdWJmVuY3J5cHRlZEFkSWQ9QTAyODg2MzgyVlUxSVIxQlROVk1EJndpZGdldE5hbWU9c3BfYXRmJmFjdGlvbj1jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ==

Amazon.com

Click to expand...

Chem77 said:

I use a ezclone and clone in 20% all the time (winter), matter of fact right now. Inside the box is 100% humidity which is what matters. I don’t mist the tops either. Always 100% success.

Click to expand...

freezeland2 said:

I am planning to up pot, take some cuttings, and then start flowering. I have a 3x3 in a different room that I am planning to run a few clones in. The humidity is very low here and that is going to be my challenge running clones.

I had two misters running on my grow and I was able to get down to one now I am preparing to flower. I moved the mister to the room where the tent is. Best I can get to with it so far is 50%. My question is will that ez clone machine running raise rh in the tent? I am hoping so. It’s still in the box and I plan to do a test but hoping someone can set my expectations. If I need another mister I want to find out now.

Click to expand...

PipeCarver said:

Your cloner doesn't take up much space you can enclose it in a small corner with some small side panels or cut the bottom off soda bottles and put over each plant, I just built a bubbler and enclosed it with a regular plastic dome.....Haven't tested it out yet its a work in progress. pics upstairs..back in 2

Click to expand...