SyLane0988
- 202
- 63
Day 45 for Daphne and day 3 for Velma
I’m hoping to see more resin around the buds soon
I’m hoping to see more resin around the buds soon
SyLane0988
- 202
- 63
Day 46 for Daphne and day 4 for Velma 
Milson
Milsonian
Supporter
- 3,376
- 263
How long are you planning to keep the humidity dome on for?
GNick55
Staff
Supporter
- 10,803
- 438
ya shouldn’t be on a seedling.. but i think we discussed that already..
can’t remember, haha..
SyLane0988
- 202
- 63
I only keep it on in the am after spraying her, that’s when the humidity is the lowest. After today I won’t be putting it on anymore and will just have to closely monitor her humidity levels since she needs more than the older plant being so young still
SyLane0988
- 202
- 63
Just in the AM when the humidity is the lowest for the first few days.
SyLane0988
- 202
- 63
So tonight I noticed some brown/yellow spots on some of my leaves. I’m very confused. No signs of pests, I check the ph of my water before every watering (5.5-6.5), been using nutrients every other watering, temp and humidity have been great (75-79 degrees, 40% humidity), fabric pot for better drainage and aeration, etc. The spots are on leaves high and low on the plant, I’m really unsure 
After doing some research, this is what I’m thinking the issue is :/ but should be treatable without losing buds
After doing some research, this is what I’m thinking the issue is :/ but should be treatable without losing buds
Last edited:
SyLane0988
- 202
- 63
I pruned the bigger plant on Friday morning to remove any leaves with brown or yellow spots. Luckily there weren’t too many. I also opened the tent and blew my bigger fan in there to get some more circulation and cleaned out the tent for any possible lingering spores. So far I haven’t seen any new spots Other than that both plants are doing well.
Other than that both plants are doing well.
KingHale
- 61
- 18
Awesome! It looks just like where I was 4 months ago. Congratulations on your good investment!! I built a rotating stand with a drainage vessel that you might like. I think it cost less than $50 for me to build myself. Remove the wheels at the bottom and you can cut that expense in half. Honestly, I never used the upper section of it and towards the end it was surrounded by clones with no room to spin but I thought I’d share because I do plan to use it again. It’s really handy for LST. I’d pull 3 colas into a triangular arrangement in each corner and rocked a full tent. Have fun either way. I look forward to checking your updates!
KingHale
- 61
- 18
I just realized there were 14 pages to that thread. Newbie. Also, not all of those pictures up there were intentional ...
oh well. Live and learn. Nice to see how well she’s done since. So much for looking toward to updates ...yay! Updates! I’m too old for forums 
still looks awesome. Happy Monday everyone! 
Milson
Milsonian
Supporter
- 3,376
- 263
Welcome to the farm! Love the DIY energy. You fit right in!I just realized there were 14 pages to that thread. Newbie. Also, not all of those pictures up there were intentional ...
SyLane0988
- 202
- 63
That’s badass, thank you for sharing!
SyLane0988
- 202
- 63
Haha no problem, glad you’re here and thank you!I just realized there were 14 pages to that thread. Newbie. Also, not all of those pictures up there were intentional ...
SyLane0988
- 202
- 63
Day 52 for Daphne, Day 10 for Velma:
Had to remove some more leaves with brown/rust spots. Still not sure if it’s actually leaf septoria or if it’s something else. Younger plant (Velma) had some yellowing around leaf tips, I believe from over watering the first two days but is looking much better now. Other than that things are going decently well. As long as the rust spots stop spreading before harvest time I’ll be adding a more powerful fan that rotates to help increase air circulation, especially with 2 plants now.
Had to remove some more leaves with brown/rust spots. Still not sure if it’s actually leaf septoria or if it’s something else. Younger plant (Velma) had some yellowing around leaf tips, I believe from over watering the first two days but is looking much better now. Other than that things are going decently well. As long as the rust spots stop spreading before harvest time
I’ll be adding a more powerful fan that rotates to help increase air circulation, especially with 2 plants now.
Last edited:
Milson
Milsonian
Supporter
- 3,376
- 263
Go velma go!Day 52 for Daphne, Day 10 for Velma:
Had to remove some more leaves with brown/rust spots. Still not sure if it’s actually leaf septoria or if it’s something else. Younger plant (Velma) had some yellowing around leaf tips, I believe from over watering the first two days but is looking much better now. Other than that things are going decently well. As lag as the rust spots stop spreading before harvest time
SyLane0988
- 202
- 63
Day 53 and Day 11:
Moved the lights above the flowering plant up, looks to be some possible light burn on the top cola. No new changes today.
Moved the lights above the flowering plant up, looks to be some possible light burn on the top cola. No new changes today.
Milson
Milsonian
Supporter
- 3,376
- 263
Jinkies! I just realized last night you should call your tent The Mystery Tent or something.
I hope those water droplets aren't focusing light on velma's little leaves!
I hope those water droplets aren't focusing light on velma's little leaves!
SyLane0988
- 202
- 63
Haha omg that’s funny, I definitely should. I’m weird and like to name all my plants
and with the critical purple, Daphne was the first name that came to mind haha. And I’m trying to lightly spray Velma in the morning for humidity since the older plant needs less RH. But you’re right, I’ve been trying to be careful with the water droplets causing any damage. It’s been tricky lol.
SyLane0988
- 202
- 63
Day 54 and day 12:
Still seeing more rust spots pop up, mostly at the top of the plant. I really don’t want to remove any of those top leaves but might end up having to. Still unsure if it’s a fungus or if it’s cal-mag deficiency from using filtered water (ph’d at 6.0) the last few waterings instead of tap like I usually do. I’m still trying to figure it out
This pic of the flowering plant this morning
Still seeing more rust spots pop up, mostly at the top of the plant. I really don’t want to remove any of those top leaves but might end up having to. Still unsure if it’s a fungus or if it’s cal-mag deficiency from using filtered water (ph’d at 6.0) the last few waterings instead of tap like I usually do. I’m still trying to figure it out
This pic of the flowering plant this morning
SyLane0988
- 202
- 63
Day 55 || Day 13
Rust spots are really spreading. At this point if I were to keep cutting off any affected leaves, most of the important fans leaves would be gone. I don’t know what to do other than let her go the remaining 3-4 weeks. Which means my younger plant having a good chance of being affected My second fan should be here tomorrow to help increase circulation.
Rust spots are really spreading. At this point if I were to keep cutting off any affected leaves, most of the important fans leaves would be gone. I don’t know what to do other than let her go the remaining 3-4 weeks. Which means my younger plant having a good chance of being affected
My second fan should be here tomorrow to help increase circulation.
Latest posts
-
First time grower looking for opinions- Imzzaudae posted
-
The 80acre- 93.Gunshots posted
-
Slight stress or just a stupid grower ?
- SnoopingAsUsualI posted
-
BWhere are the Classic strains?
- Budclarkson posted
-
Buds & bugs outdoor pics collection- Poekie posted