Cashmeh
- 2,007
- 263
4x8 room and it happens they sell sheets of foamboard in 4x8 sheets :) I plan on cutting 6 square holes for my square 5.3 gallon buckets and sliding the board flush with the lids. Ill put the lids on, make it all almost flush, lay the mylar, and cut the holes for the lids, remove buckets tape down mylar, attach mylar to lid, and yea. I will have plenty of circulation in the tent due to exhuast fan and inlet an being above the foam, with plenty of fans.
Im finding that searching for all black tubing, fittings and buckets to be expensive. I want it to be 100% light proof. I realize all the tubing with water will draw light if the res area outside the tent is not light proof also, so that will be taken care of also.
I also need input on how far apart to space the buckets. It will be 6 plants in a 4x8, rdwc top feed. 1 inch supply, 3 inch return.
Here is my parts list too incase you all see an issue here.
602gph electromagnetic air pump
480gph water pump
7 5.3 gallon buckets and 6- 6 inch netpots
3 inch return pvc bulkhead fittings
1 inch feed rubber hose/bulkhead fitting
400ft 2ml mylar
2 -6in 240cfm fans
6 airstones with suction cups
1 - 1000w mh/hps hid tube ballast with junk ass reflector lol
The picture shows the spacing im asking about between buckets. Should I keep them close together under the 1000w or spread them out. About how far apart should these center of each netpot be? Top or bottom in the picture. Buckets are 1ft wide, well 11.5
Im finding that searching for all black tubing, fittings and buckets to be expensive. I want it to be 100% light proof. I realize all the tubing with water will draw light if the res area outside the tent is not light proof also, so that will be taken care of also.
I also need input on how far apart to space the buckets. It will be 6 plants in a 4x8, rdwc top feed. 1 inch supply, 3 inch return.
Here is my parts list too incase you all see an issue here.
602gph electromagnetic air pump
480gph water pump
7 5.3 gallon buckets and 6- 6 inch netpots
3 inch return pvc bulkhead fittings
1 inch feed rubber hose/bulkhead fitting
400ft 2ml mylar
2 -6in 240cfm fans
6 airstones with suction cups
1 - 1000w mh/hps hid tube ballast with junk ass reflector lol
The picture shows the spacing im asking about between buckets. Should I keep them close together under the 1000w or spread them out. About how far apart should these center of each netpot be? Top or bottom in the picture. Buckets are 1ft wide, well 11.5