THCFarmer.com
121,256 Members Log In Register
Log In Register

Fresh Run. Fresh Room

  • Thread starter Thread starter tattoojim
  • Start date Start date
  • Tagged users Tagged users None

Fresh Run. Fresh Room

tattoojim 26,484 Replies 1,902,770 Views
Page 1278 of 1325 · Replies 25,541–25,560 of 26,485
#25,541
blazer said:
I know you can make wind generators with three phase motors also
Click to expand...
I think any electric motor can be used to generate electricity
str8smokn said:
If you wire up a 3-phase motor wronge it runs in reverse.
I work on 3-phase pool pumps a lot,heavy mothers.
They are usually your 10hp commercial motors.
Good morning men..
STR8
Click to expand...
From what I've seen all electric motors will run opposite direction if polarity is reversed
str8smokn said:
They are around 50lbs or better,but when your holding it 4" off the ground to slide into place it sucks. The Brass Impellar is about 7lbs,and that's what actually moves the water.
STR8
Click to expand...
The 10 horse Baldor motor on my air compressor weighs about 150 pounds, it was a pain in the ass to rebuild and clean up.
 
#25,542
mittenmedgrow said:
I think any electric motor can be used to generate electricity

From what I've seen all electric motors will run opposite direction if polarity is reversed

The 10 horse Baldor motor on my air compressor weighs about 150 pounds, it was a pain in the ass to rebuild and clean up.
Click to expand...
three phase will create the power cause all three windings are the same size, only reverse the three phase with reversing polarity
 
#25,543
blazer said:
three phase will create the power cause all three windings are the same size, only reverse the three phase with reversing polarity
Click to expand...
If it wasn't for this I might remember half of what I learn.
20160407 231458
 
#25,544
mittenmedgrow said:
I think any electric motor can be used to generate electricity

From what I've seen all electric motors will run opposite direction if polarity is reversed

The 10 horse Baldor motor on my air compressor weighs about 150 pounds, it was a pain in the ass to rebuild and clean up.
Click to expand...

No regular 120/220V motors (for pools) can't be wired up backwards.
It's like either lead can be a common or hot. You just hook up both wires and your ground and your golden.

And Baldor makes some beast too. I've messed around with them too.
Depending on how yours mounts to the compressor,you can use 6" threaded bolts /all threads with no head on them. Screw them into whatever the motor mounts to and use as a guide,and holds the motor in place, while you screw the right bolts into place.
STR8
 
Page 1278 of 1325 · Replies 25,541–25,560 of 26,485
Back
Top Bottom