DoomGada
- Posts
- 11
- Joined
- Feb 5, 2014
- Points
- 3
Eastern Washington. I think we have decided to buy six window shakers for the time being, unless you think we could get away with three and circulate between rooms.
Eastern Washington. I think we have decided to buy six window shakers for the time being, unless you think we could get away with three and circulate between rooms.
Yes we will probably do that, the bonus is heating and the dehumidifier.Would be better if each room had its own unit.
How much drag do you thin using 6" vented would put on the fan pulling through the hoods?
12 w x 20 longDepends on length of run. Longer runs will move much less air.
12 w x 20 long
12 x 20 x 8 /3 x 5% x 8 1000 watts lights(if this is correct), i figure A 10 fan that does at least 1000cfm, we will probably have an intake fan directly across the room towards the floorIt depends on how much air you want per light per minute. You will need that number and info about fan you are using to figure this out properly.
John do you know of a way to bypass Mitsubishi thermostat so I can hook it up to my Enviro Controller to activate it when needed.
2-30k Btu units.
I have 2 MHK-1 thermostats but I was told by Mitsibishi that the thermostat is proprietery to the Mitsubishi Air handler.
Honeywell Gateway seems like a moot point unless I add exterior thermostats and the inability to cycle between modes when setting a schedule anyway.
I'd rather control my Enviro through a VPN (pc to controller or iPhone to controller) as opposed to the gateway which is rather limited.
I watch my VPD closely.
@CannabisJohn How's it going?
What do you think of this mini split and it's ability to keep a 12'x14' room with 6000 watts, CO2, dehuey cool?... the ballasts are not in the room. I figured 1 unit on either side of the room would work better for coverage...?
5 pin connector connector from the Air handler to thermostatI have never looked into it. But I took a brief look. I do not see a direct way except thru Honeywell gateway. Maybe able to be done with some relays but not sure best way to do it.
12 x 20 x 8 /3 x 5% x 8 1000 watts lights(if this is correct), i figure A 10 fan that does at least 1000cfm, we will probably have an intake fan directly across the room towards the floor
5 pin connector connector from the Air handler to thermostat
Hey CJ I'm in Los Angeles and I installed a 25k window unit in a closet doorway of a 10x10 room with 4 k open hoods. It's working killer. I put a vortex fan in the ceiling of the closet to take any heat outta the closet. My question is....when I open my special door I made for the water bucket...there's no water??? Not a drop. Is that because my ac unit is overkill for such a small room? I also installed a grate in the closet floor pulling cold air from under my house for the ac. Thx
50s with dehuey...wish it was lower
Btw it's my flower room
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?