Mike49048
- 91
- 8
This is my first grow in a long time and the first using the 1500w.
I am flowering in a 10 x 8 ft space and have the moms in a 4 x 7 space. I really just getting started and still have many items yet to get. So far I am running:
Equipment
*one 1500w Masterblaster hps light with the xxxl magnum *reflector "ocho"
*745 cfm fan for cooling the light
*45 pint dehumidifier
*10000 btu portable a/c, haven't needed to use yet
*250w mh
*six 4' florescent lights
Equipment to come in the near future
air filtration, ph and ppm meters, another 1500w hps light, Co2 system also planning on buying 13 2'ft pineapple kush clones to put right in to flower
Nuts: Need help here any suggestions are appreciated.
*Dyno-Gro Grow for Veg
*Dyno-Gro Bloom for Flower
I using one teaspoon to a gallon of water
I haven't been able to ph or ppm the water yet, I need to pick up the meters.
medium
Farfard C-1p Mix (Green Bag)
Plants
2 moms from seed of Nirvana blackberry female seeds
9 clones
The moms are under 24hr of light w a 250w mh and four 4' florescent lights they are about 6'ft tall would be bigger if I wasn't bending them.
The clones were vegged under six 4' florescent lights until 3' tall then put under the 1500w hps for flowering
The 1st wk of flowering I had temp. problems, the room was getting up to 99 degrees f when the lights were on and got down to 54 degrees for a night or two because I covered up the heat vents. This was fixed when I exhausted the heat from the light and under covered one of the heat vents. The room now is between 72-81 degrees.
Equipment and Nuts and stuff
I am flowering in a 10 x 8 ft space and have the moms in a 4 x 7 space. I really just getting started and still have many items yet to get. So far I am running:
Equipment
*one 1500w Masterblaster hps light with the xxxl magnum *reflector "ocho"
*745 cfm fan for cooling the light
*45 pint dehumidifier
*10000 btu portable a/c, haven't needed to use yet
*250w mh
*six 4' florescent lights
Equipment to come in the near future
air filtration, ph and ppm meters, another 1500w hps light, Co2 system also planning on buying 13 2'ft pineapple kush clones to put right in to flower
Nuts: Need help here any suggestions are appreciated.
*Dyno-Gro Grow for Veg
*Dyno-Gro Bloom for Flower
I using one teaspoon to a gallon of water
I haven't been able to ph or ppm the water yet, I need to pick up the meters.
medium
Farfard C-1p Mix (Green Bag)
Plants
2 moms from seed of Nirvana blackberry female seeds
9 clones
The moms are under 24hr of light w a 250w mh and four 4' florescent lights they are about 6'ft tall would be bigger if I wasn't bending them.
The clones were vegged under six 4' florescent lights until 3' tall then put under the 1500w hps for flowering
The 1st wk of flowering I had temp. problems, the room was getting up to 99 degrees f when the lights were on and got down to 54 degrees for a night or two because I covered up the heat vents. This was fixed when I exhausted the heat from the light and under covered one of the heat vents. The room now is between 72-81 degrees.
Equipment and Nuts and stuff