5ecret 5quirrel
- 271
- 63
aluminum? i tried to get the same dimensions as the tutorial but mines 5 cobs instead of 4 and a quarter inch wider.What heatsink did you get?
You are running the same wattage driver so you probably still need a fan. I went with 5 COBs at 1400mA and got a 4' chunk of heatsink so I could skip the fan.aluminum? i tried to get the same dimensions as the tutorial but mines 5 cobs instead of 4 and a quarter inch wider.
1.2 meters3' long?
i have no idea how many amps i'm using . . .You are running the same wattage driver so you probably still need a fan. I went with 5 COBs at 1400mA and got a 4' chunk of heatsink so I could skip the fan.
Very nice! Professional looking. Check out Growmou5 video on Youtube. He has very similar design and nice tutorial.1.2 meters
View attachment 561685
it's a bit different i can run 5 cobs with this one.
it check it over at rollitup.com
View attachment 561686
can't see the fan on the back, but it's on there : )
Very nice! Professional looking. Check out Growmou5 video on Youtube. He has very similar design and nice tutorial.
Update,looked real nice.should i add some UV lights?
View attachment 563329
I added far red led diodes semileds from stevesleds also an LDD-700 for up to 6 leds. There is a far red led on riu. Peaceshould i add some UV lights?
View attachment 563329
why do you add far red? and how many watts?I added far red led diodes semileds from stevesleds also an LDD-700 for up to 6 leds. There is a far red led on riu. Peace
I've been using uvb reptile bulbs,and uvb strip lights t8s...done side by sides,with and without....they do make more sticky buds,very resinous...check out my thread.i got a pal on here who has spent dollars on proper supplemental uvb t5 fixtures..he agrees with me...uv does make a nice diff.just bought eight 60w florescent UV lights for the last 2 weeks of flower. UVA and UVB combo. 15 in. above the canopy.
Philips TL 60W/10-R SLV/25 $25 usd
View attachment 668124
QUV UV-B 313nm Lamp (Knockoff). $35 usd
View attachment 668123
I had the lights on for about an hour before reading:
Because all UV-B lamps emit unnatural, short-wavelengths of UV that are below the solar cutoff of 295 nm, anomalous results can occur.
then i got real nervous that the UVB wave lengths under 295 nm would damage the THC on the buds. needless to say the UVB 313nm lights are off, but i kept the UVA florescence "ON" and running.
The Whole goal was to peak at 280-315nm to hit the UVR8 (ultraviolet-B receptor UVR8) but not i'm to scared to go through with it.
Any wisdom from the community would be greatly appreciated.
so you don't think it's possible to burn the ladies with this spectrum?I've been using uvb reptile bulbs,and uvb strip lights t8s...done side by sides,with and without....they do make more sticky buds,very resinous...check out my thread.i got a pal on here who has spent dollars on proper supplemental uvb t5 fixtures..he agrees with me...uv does make a nice diff.
hope this helps pal...keiks...
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?