Log In Register

Piña Colada and coconuts :)

Follow Piña Colada and coconuts :) on THCFarmer with grow updates, member discussion, images, and cultivation notes.
Home Forums Medical Cannabis Cultivation Grow Diaries Piña Colada and coconuts :)
Grow diary eligible · Medical Cannabis Cultivation

Piña Colada and coconuts :)

by Sunin · Started
1d
Running
0
Updates
476
Replies
0
Images
Discussion below · 476 replies
Page 14 of 24 · Replies 261–280 of 477
And you had them at 26 inches you said?
 
Last edited:
And you had them at 6 inches you said?

canopy is now 26"-32" from light in different points

and this is the new one that will jump in on monday. will toast them even more so yes? 😂

450877385 783334803965046 151851348816965741 n
 
Last edited:
Sorry I meant to say 26 not 6 (corrected), they would be all ashes by now hahahaha. So at 26 inches you should be able to use full potency according to the PPFD chart. I dont know why you keep saying they are toasted, they are not. One of them is moving leaves perhaps to avoid light but even that one is not burned in any way, no yellowing on the edges and very little on the tips which could be nute related or if its light is not enough to worry about.
 
Thats what I would do yes hahaha. I have not used high end panels so maybe they are a bit more agressive than the ones I use so I would be watching for signs after cranking it up but I would definetely try to give them full potency at that distance.
 
Thats what I would do yes hahaha. I have not used high end panels so maybe they are a bit more agressive than the ones I use so I would be watching for signs after cranking it up but I would definetely try to give them full potency at that distance.

ok. it's on 8 now- slightly over 500W 🤞

in case it will be your fault 🤣
 
ok. it's on 8 now- slightly over 500W 🤞

in case it will be your fault 🤣
Hahaha dont worry you will have plenty of time to lower potency if you see any tip getting crispy. Thats no biggie, I crisp them a bit sometimes when pushing light or nutes and then back off when I see them crispy tips. 98% of the leaf is still gonna do its job and it wont progress if corrected.
 
I try to push 1200umols in the middle, I have to keep them way closer than you because my panels are 2x130W and 2x150W respectively in each tent. Your panel says that at 12 inches it gives 1200umols in the middle so I wouldnt even worry about them getting too close to the light with the stretch, you have a lot of margin.
 
Last edited:
What temperatures do you get with the panel on full blast? At some point it is better to back off but if its like 30ºC which is 3 above the maxium recommended I would say go for it. Id rather give them a few more degrees than optimal than way less umols than optimal. You could dimm it a bit towards the end, they will mature faster when sensing the change of light potency and you will evaporate less terpenes. (Which they recover at night anyway but maybe not all of them if the temperature is not optimal)
 
What temperatures do you get with the panel on full blast? At some point it is better to back off but if its like 30ºC which is 3 above the maxium recommended I would say go for it. Id rather give them a few more degrees than optimal than way less umols than optimal. You could dimm it a bit towards the end, they will mature faster when sensing the change of light potency and you will evaporate less terpenes. (Which they recover at night anyway but maybe not all of them if the temperature is not optimal)

barely 25C now, slowly climbing. will leave them a bit and maybe put new one on half- 500W and then test up
prefer not to overload them- they seem very sensitive 🤣
I always go down last week and a half- in HPS I was swapping for 200W less. Think with LED I shall do more or less the same
 
I was standing over my pineapples in the evening with delicious purple haze joint from my friend stash watching humidity raising (3 points of measure- lung room, floor of the tent, probe hanging) and I've open the tent 360 and put my hand into some places of the canopy- humid, cold, just unpleasant 😐
so:

DSC 9003


all the weak shoots, all crappy shoot with big fat mamma close, all popcorn after lollipop, all yellowing and crappy ones from under the net and then difficult part (that one took me two hours and two joints 😆 )- healthy fans from colas, some of them beautiful. I tried to be very conscious about it leaving few fans each

thinned pig weeds


Thinnedpigweeds


Part of them is going into characteristic pineapple crown. I left them also a bit more of space
Took me half an hour with the loupe and trimmed stuff to assess- all good, nice crust forming even on rejected ones, no pests, bit of nute burn.
decision was good as loads of crap was neon green from lack of light- that crap is gone
Hope I did more or less good stoned job 🤣🙏

Difference in humidity after system went sleep- 10% 👌
And they took 500W without a burp so far 🤞

Hard core this small lady grow 🤪😎

May fairies of stable VPD stay with you 🤟🍍
 
Ma'am if you keep putting that much effort youre gonna end with too much weed! Just joking there's no such thing as too much weed in my book hahaha, theyre looking lovely and super packed. Whats the max registered temperature now? Same as before? 25ºC? Let me know if you go to 100% how much it goes up. 25ºC is totally fine, as you said you will reduce intensity and hence also heat when its time.
 
Ma'am if you keep putting that much effort youre gonna end with too much weed! Just joking there's no such thing as too much weed in my book hahaha, theyre looking lovely and super packed. Whats the max registered temperature now? Same as before? 25ºC? Let me know if you go to 100% how much it goes up. 25ºC is totally fine, as you said you will reduce intensity and hence also heat when its time.

26 with heater but I pump VPD as I want to full feed soon.
Outside Atlantic weather again 🌪️🌧️
I am at home anyway- surrounded by small dogs this weekend 🤟
tomorrow dogs and workers 😂
And I think I did good work yesterday, stacking up started properly- your truly was just in time with good light penetration delivery 😉

peekaboo 🫣

11 08 24


oh and you wait a moment with this full blast- tomorrow I will install that big columbryna 1000W, will set it on half- 500W.
I don't think overall people are going over 700-800 anyway do they?
Will give them few days to adjust to UV there and power overall and load calmag in them on occasion

Look at you willing to burn my pineapples so frivolous 😉😏😂

😘
 
Last edited:
I was standing over my pineapples in the evening with delicious purple haze joint from my friend stash watching humidity raising (3 points of measure- lung room, floor of the tent, probe hanging) and I've open the tent 360 and put my hand into some places of the canopy- humid, cold, just unpleasant 😐
so:

View attachment 2241164

all the weak shoots, all crappy shoot with big fat mamma close, all popcorn after lollipop, all yellowing and crappy ones from under the net and then difficult part (that one took me two hours and two joints 😆 )- healthy fans from colas, some of them beautiful. I tried to be very conscious about it leaving few fans each

thinned pig weeds


View attachment 2241165

Part of them is going into characteristic pineapple crown. I left them also a bit more of space
Took me half an hour with the loupe and trimmed stuff to assess- all good, nice crust forming even on rejected ones, no pests, bit of nute burn.
decision was good as loads of crap was neon green from lack of light- that crap is gone
Hope I did more or less good stoned job 🤣🙏

Difference in humidity after system went sleep- 10% 👌
And they took 500W without a burp so far 🤞

Hard core this small lady grow 🤪😎

May fairies of stable VPD stay with you 🤟🍍
LOL atta girl rock that friggin room🤪
 
Let me know if you go to 100% how much it goes up.

I checked the highest ends today at closing after all day of 500W
Looks good. Tempting to crank up 😂 what do you think? hair nice and white, bit of burned ends here and there
maybe they will handle more? ⚡

DSC 9036


just two of them putting teeth up but overall looks like they are loving it

DSC 9031


Weird one got a bit better- hard to say what helped her- my treatment, more light, or both
Storm here today with thunders and crap
Can't keep dogs out of my relax area 😂 everybody wants to suntan

Suntan


and listen to oriental covers 🤣😘



🫶
✌️
 
I always go down last week and a half- in HPS I was swapping for 200W less. Think with LED I shall do more or less the same
Once I got my lights set (which took a few tries the girls were touchy with that) I didnt mess with it again. I’ve never used HPS though. I have heard (and could have totally been “bro science”) that some would have the setup dim a little towards the end of the 12 hours at the closer end of the cycle. Mimicking a sundown affect. Sounds kind of like what you’re talking about maybe : ) maybe not at all 😂🤷🏼‍♂️ ✌️
 
I checked the highest ends today at closing after all day of 500W
Looks good. Tempting to crank up 😂 what do you think? hair nice and white, bit of burned ends here and there
maybe they will handle more? ⚡

View attachment 2242081

just two of them putting teeth up but overall looks like they are loving it

View attachment 2242082

Weird one got a bit better- hard to say what helped her- my treatment, more light, or both
Storm here today with thunders and crap
Can't keep dogs out of my relax area 😂 everybody wants to suntan

View attachment 2242089

and listen to oriental covers 🤣😘


View attachment 2242095
🫶
✌️
As long as you crank up slowly you should be fine. According to their PPFD chart at least, there's also the factor to consider on how much light theyre used to. If theyre only now getting the optimal umols they might not be able to reach 1200umols in the middle but even at 26" your panel is giving "only" a bit less of 800 in the middle so its quite safe or should be. Those are samsung diodes they do a much better job at not burning your plants than cheap diodes but they're also quite potent compared to the cheap ones... so you have the potential to have better plants or burned plants 😂 . At that distance and that temperature you should be totally fine though.
 
Honestly I dont think they can handle 1200umols if theyre not used to high intensity from the start. I think many can start to show symptoms of too much light even at 1000umols, but again youre not over 800 so you should be fine.
 
Page 14 of 24 · Replies 261–280 of 477
Back
Top Bottom