Mr.jiujitsu
- 1,701
- 263
So I decided I wanted some super low cal edibles and decided it was time to try making gelatin filled capsules. I purchased this, “All
In Capsule” , that allows a used to fill 100 capsules at a time.
I watched the video, unpacked and verified it came with all listed components. I had destemmed a full Ardent Lift canister of some recently cured “white widow” that I have been using for lots of my edibles.
I purchased these gel caps.
I found that they fit very well In The capsule filler.
I used a hand grinder to prepare the cannabis, but believe and electric grinder that would grind it super fine would be best. I noticed as I filled the capsule filler with capsules that the designed way to load it isn’t really effective. My capsules came attached so since I had to separate them I hand loaded each long end. When it came for the short ends I just dumped and gave a gentle shake. I found about 80% went the right way and 20% I had to flip over, only took a moment. I did notice one end cap was slightly damaged and I left it in place to see what happens. Well I followed the supplied directions and it worked perfectly. The one that was damaged didn’t make a mess but I did end up removing it. I had almost zero loss of material, and filled 99 out of 100 perfectly. The manual grinding took the most time aside from the decarb run.
So far I have used this once. I absolutely love it and will continue to update as time goes forward. I hope to do some more investigating and get some numbers on thc content and dosing.
All of these products have been purchased off “Amazon” for 36$.
In Capsule” , that allows a used to fill 100 capsules at a time.
I watched the video, unpacked and verified it came with all listed components. I had destemmed a full Ardent Lift canister of some recently cured “white widow” that I have been using for lots of my edibles.
I purchased these gel caps.
I found that they fit very well In The capsule filler.
I used a hand grinder to prepare the cannabis, but believe and electric grinder that would grind it super fine would be best. I noticed as I filled the capsule filler with capsules that the designed way to load it isn’t really effective. My capsules came attached so since I had to separate them I hand loaded each long end. When it came for the short ends I just dumped and gave a gentle shake. I found about 80% went the right way and 20% I had to flip over, only took a moment. I did notice one end cap was slightly damaged and I left it in place to see what happens. Well I followed the supplied directions and it worked perfectly. The one that was damaged didn’t make a mess but I did end up removing it. I had almost zero loss of material, and filled 99 out of 100 perfectly. The manual grinding took the most time aside from the decarb run.
So far I have used this once. I absolutely love it and will continue to update as time goes forward. I hope to do some more investigating and get some numbers on thc content and dosing.
All of these products have been purchased off “Amazon” for 36$.