mstrpkl
- Posts
- 633
- Reactions
- 1,295
- Joined
- Jul 23, 2024
- Points
- 143
Well as i said in my post, i took snapshots of each with and without a diffuser. I totally agree i think the app is trippin when it says the ppfd is 2800 lol but i do think around 900 is more accurate. Around 1100 would be enough to sunburn the leaves at this stage, so thatd make sense when i had my light at 100% i was getting around 1100ppfd.You need to get a piece of paper wrapped around the top of your phone with tape on the back. This will take the diffuser warning off the app and make your Photone app actually work. There’s no way you are getting 2k ppfd off that light. The way I know is the manufacturer ppfd tent map doesn’t go that high. It’s okay it’s just the app being weird without the step it said for you to follow being completed
Phone cameras pretty good, but thats why i used 2 apps lol cuz i dont trust a single source. And used a diffuser with both apps as wellaccuracy of the photone app will depend on the quality of the camera inside the phone, some phone with low end camera will give funky results with the photone app ...
Keep it in veg light. Since it is bag seed you could have an auto. I grew a seed I found in my trim once from like a year previous harvest. Somehow that seed grew into an auto in my solo cup container. It smelled like blueberry. So weird I never even bought an auto seed until like 5 months ago so there’s no way it could’ve been a seed I misplaced. If you switch to 12/12 and it’s flowering you could lose out on 1/3 of your yield or moreI think shes trying to flower without the light switch. What should i do here? Let it ride in veg light cycle and hope it reverts or flip and let her flower?
I don't see any buds, I just see female pre-flowers. Are there buds forming that you didn't take pictures of, or is it just the white hairs confusing you? When in veg for long enough, plants will show their sex, and the sex yours is showing is female. White hairs come out of those pre-flowers.I think shes trying to flower without the light switch. What should i do here? Let it ride in veg light cycle and hope it reverts or flip and let her flower?
I didnt see any buds, just those very few hairs. I went looking around and yea shes most likely just showing right now. Which is great! Happy to see what i wanna see lolI don't see any buds, I just see female pre-flowers. Are there buds forming that you didn't take pictures of, or is it just the white hairs confusing you? When in veg for long enough, plants will show their sex, and the sex yours is showing is female. White hairs come out of those pre-flowers.
I just used a 3 in 1 meter to mesure the ph, also measures light and moisture, but that thing said the ph is somewhere around 7-7.5, so as long as that thing is correct i dont think it should be a ph problem. Those things arent 100% accurate, but its what i have access to for now haha and i water with just distilled water too so ph of the water shouldnt be affecting anything. Il have to get a more accurate device to measure the soils ph though.it's just preflower
hopefully it's photoperiod so. just watch it.
that brown patches look more like PH not light
none of the less light is too strong. I would put down puffididies measurements on the side and just look at the plant
what's your distance now in cm and W?
she ready to flower, add the stretch, might be tight?
Yea i agree i dont think this moisture meter is worth its weight lol il get a new ph meter and post for everyone to see.well- when something is for everything it's usually for nothing
I was asking about PH as twisting like this might be also a PH issue. With light stress cannabis ends are tacoing up
on the next job you can also hang it properly and position it as I can see that you have this light on one pulley and crooked
even weight of cables on light affect panel
I would raise it by 5cm and take care of full and even footprint installing it on more pulleys
greets and good luck
Nice thanks for the suggestions on the ph meter! Il probably buy one of those in the next couple days. That meter im using now was just because i was being impatient and wanted something immediately, and i was putting too much trust in the moisture meter lol doesnt do shit for me so far. Thanks again dude!This is where having accurate measuring tools comes in handy. The 3 in 1 is junk. I've used them in the past and your soil pH can vary depending on your watering practices along where you inserted the probe tip. It can say bone dry half way into the bag but say wet if you go down a couple more inches.
Honestly I would suggest you use pH strips before I would trust the 3 in 1. I realize money is tight but having a good way to measure pH and PPM/EC will take your grow skills to another level. Having that dataset to refer to will help in making decisions and adjustments to steer your plant to harvest.
My suggestion would be to buy a pen or pens that can measure both. I've used BlueLab pens for decades and they've always been reliable. Apera is another brand that has gotten rave reviews for it's economy and performance. The Apera pen has a replaceable probe tip which is nice along with being able to measure PPM/EC in one package. BlueLab separates its pH and PPM/EC pens and the probe ends aren't replaceable but as long as you maintain the pens they will last you for many years.
Hahahaha hell yea il check that thread out too! Thank you lol thats pretty hilariouswait- I have mistaken two threads
your and https://www.thcfarmer.com/threads/indoor-led-soil-scrog-green-crack-auto-fast-buds.161127/
apologies
I think you might guys help each other :D
give her time so to adjust to new light. better raise it too high and lower it down than the other way around
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?