bankcee
- 488
- 63
Yes.
Cut the plug off, or disconnect the other end.
Run the cable through grommets.
Then re-attach one end, or the other.
I thought of that but I didn't wanna cut he hole and it not work and then me have ruined a good tote lolCut the hole and use a Neoprene Puck to cover the hole and hold the cord.
Notch the lid at the edge, and partially the edge of the bucket if needed. Cutting a hole in the side of the bucket leads to dripping.
Put the disc inside the bucket not outsideI thought of that but I didn't wanna cut he hole and it not work and then me have ruined a good tote lol
I'm gonna cut it smaller than a 2 inch though so it's a real snug fit.
Cutting a slot, in the edge of the lid, the width of the cord. Allows the cable to leave the cloner, while still keeping the lid on flat. I've notched the top edge of a container, just enough to allow the cord under the lid, and had it work out ok without dripping. Rather cut a perfect notch in the lid though.
Could not find this thread. I have the 27g black and yellow tote would you mind linking it?If this is the same black base/yellow lid tote, I made the same cloner (see diy subforum).
Could not find this thread. I have the 27g black and yellow tote would you mind linking it?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?