THCFarmer.com
121,131 Members Log In Register
Log In Register

Waxtractor Mule?

  • Thread starter Thread starter ftwendy
  • Start date Start date
  • Tagged users Tagged users None

Waxtractor Mule?

ftwendy 64 Replies 8,403 Views
Page 4 of 4 · Replies 61–65 of 65
#61
donmekka, I've been out of the office for a few days. I haven't seen any emails come across, but I will check the voicemail when I'm back on Monday.
 
#62
Graywolf said:
The scientific glass shop that we use, could without question fix it, so there are no doubt artistic glass blowers qualified in your local area.

Does it look like a fatal flaw that will reoccur without design upgrades? Was it cold when you tapped it?
Click to expand...

No it wasn't cold and as far as a design flaw or defect I have no idea I am not qualified to make that call .I'll work on getting pics later.
 
#63
@timtractor hey bro I called June 3rd also emailed around the same time and replied to your message here. Just figured you guys were busy.Also hope you don't think i am putting you guys down Just reporting my experience for others.I am gonna try and get this one fixed cause i will say when it is not broke it is awesome. But just can justify buying a new one at this current time.
 
#64
Graywolf said:
Does it look like a fatal flaw that will reoccur without design upgrades? Was it cold when you tapped it?
Click to expand...

I had one of my Mules fail at the exact same place on the tube, at the bend below the fritted disc, but mine was under pressure! The break happened when I was unscrewing the valve to release the liquid butane for evap., and you can bet I was being gentle because this is already a replacement valve on the tube. . . thank the gods of planning for safe practice and a good environment..... Sheesh. What a mess, what a waste.

Be careful. These things are UBER fragile... I still like the idea, but this is an unacceptable failure imo
 
#65
ftwendy said:
I had one of my Mules fail at the exact same place on the tube, at the bend below the fritted disc, but mine was under pressure! The break happened when I was unscrewing the valve to release the liquid butane for evap., and you can bet I was being gentle because this is already a replacement valve on the tube. . . thank the gods of planning for safe practice and a good environment..... Sheesh. What a mess, what a waste.

Be careful. These things are UBER fragile... I still like the idea, but this is an unacceptable failure imo
Click to expand...

Hey ftwendy, your security settings won't allow me to send a private message. We're moving into stainless steel in a similar setup and away from the glass. I've got a number of the glass units pressure tested and coated, I'd like to replace the broken one for you. Hit me up and let me know if you would like one.
 
Page 4 of 4 · Replies 61–65 of 65
Back
Top Bottom