VinnieV
- 124
- 43
Hello folks!
So I’m taking on a slightly bigger space - two F rooms and a V room. I’m looking to have all three spaces vent through 8” ducting, a carbon filter, corona discharge ozone then vented outside. For safety I want to vent this above the roof of my building - 12 meters from ground level. basically this me be a bit outside my skill set! So I’m wondering if anyone has any resources for calculations etc that take into consideration bends, length of run etc.
The rooms are 4m x 4.5m
the fans are Q-Max 8” - 1120m3/h and will likely never be run above 50-60%.
as far as bends go for the one pipe (10”? 12”? Bigger?) that is external and carrying to the roof, there will be:
a 90 degree bend going up 2 meters
a 45 degree bend going 4/5 meters
Another 45 degree bend taking it straight up again where it will go around 6/7 meters until it terminates. Likely with a roof cowl.
im hoping I can get pointed in any direction that takes my head out my hands...
So I’m taking on a slightly bigger space - two F rooms and a V room. I’m looking to have all three spaces vent through 8” ducting, a carbon filter, corona discharge ozone then vented outside. For safety I want to vent this above the roof of my building - 12 meters from ground level. basically this me be a bit outside my skill set! So I’m wondering if anyone has any resources for calculations etc that take into consideration bends, length of run etc.
The rooms are 4m x 4.5m
the fans are Q-Max 8” - 1120m3/h and will likely never be run above 50-60%.
as far as bends go for the one pipe (10”? 12”? Bigger?) that is external and carrying to the roof, there will be:
a 90 degree bend going up 2 meters
a 45 degree bend going 4/5 meters
Another 45 degree bend taking it straight up again where it will go around 6/7 meters until it terminates. Likely with a roof cowl.
im hoping I can get pointed in any direction that takes my head out my hands...