jguit
Supporter
- Posts
- 905
- Reactions
- 1,675
- Joined
- Feb 27, 2018
- Points
- 143
Looks like much smaller pots. Maybe you should give the 20L pot a little time to dry out after your next feed.
121,282 growers, practical cultivation threads, real grow diaries, and community advice.
Create account → Already a member? Log inFollow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Ye if read and been told old that a few times, you read all sorts off opinions tho, but that pops up a lot in forums it's ment to have plenty,Canna doesnt publish their ratios but i found this a while back. If this analysis is to be trusted, it looks like their A/B line has plenty of calcium in it already. That said, I can not personally verify the accuracy.
![]()
Where Is Canna Hiding Their Calcium?(the Truth Behind Canna Nutrients)
Hello fellow cultivators, Something has been bothering me recently, where is the calcium in Canna's Coco line? Every major article and research paper I've studied has emphasized a minimum of 1.5:1 and a common maximum of 3:1 or 4:1 ratio of Calcium : Phosphorous. Based on Canna's 'Guaranteed...www.thcfarmer.com
Here is the back of the bottle and all the stuff in it seeYea, 1.2 EC isn't terribly high at all.
Lost me a little bitThis is calculated at their full strength recommendation of 10ml per gallon.
I'm running just about the same calcium/nitrogen ratio with Jack's 5-12-26 and PureCal CalNit without issues.
View attachment 1225192
5-12-26 is the NPK ratio of the dry salts i'm using (Jack's)Lost me a little bit
Do you mean 5-1.2-1.6 not 5-12-26 im looking at the chart, guess that chart is your nutrients label off bottle?
I am using Jack's 5-12-26 and PureCal 15-0-0 CalNit (18% Calcium) and the ratios of Nitrogen/Calcium at the ratios i run them at are about the same as your base nutrients without additional calmag. (Jack's 5-12-26 (A) plus CalNit (B) is a base feed, just like your Canna AB)So you mean your using jacks base feed and calmag and that comes to the same ratio as my a&b without calmag?
I do not use any CalMag suppliments.Or you mean your base is about the same ratio and then your also adding calmag on top with no problems?
Short for Calcium Nitrate (Dry salts)What's cal nit?
I wouldn't have flushed them with the .2 EC tap water as you did. I mentioned above that this would happen! haha.. You stripped (flushed) all of the salts out of your media. You'll have to run your 1.2 EC input feed until runoff equals 1.2 ECI fed them 1.2 Out was just 0.4 I would of like to run 1.2 through them till out is the same but it's bloody hard work getting in their with a pump to drain the wast from the trays.
Do you think it be ok ,or would you run 1.2 through them till out was 1.2?
Your feed has 4.5% Calcium. My fertilizer are A/B dry salts not unlike your liquid feed. Same stuff, just more economical. The Calcium Nitrate contains the calcium (and nitrogen). I do not use a CalMag supplement.I think I'm slowly getting their lol my base nutes contain 2.4% magnesium
And 6.3% calcium so my base it's a has more than yours and your adding calmag and its workout about same as mine a&b without added calmag
This stuff gets confusing. It took me a bit to get a decent grasp on it.Hope I'm right or I'm gonna look stupid;)
Gutted maybe I could feed 1 hight e.c in like 1.8 once and 1.2 day after think it will work? They gonna be yellowig soon then5-12-26 is the NPK ratio of the dry salts i'm using (Jack's)
I am using Jack's 5-12-26 and PureCal 15-0-0 CalNit (18% Calcium) and the ratios of Nitrogen/Calcium at the ratios i run them at are about the same as your base nutrients without additional calmag. (Jack's 5-12-26 (A) plus CalNit (B) is a base feed, just like your Canna AB)
I do not use any CalMag suppliments.
Short for Calcium Nitrate (Dry salts)
I wouldn't have flushed them with the .2 EC tap water as you did. I mentioned above that this would happen! haha.. You stripped (flushed) all of the salts out of your media. You'll have to run your 1.2 EC input feed until runoff equals 1.2 EC
Ok thanksI would advise against feeding high to compensate. Get your runoff to match your input feed.
im running RO water.. correct!
HayI would advise against feeding high to compensate. Get your runoff to match your input feed.
im running RO water.. correct!
Use a no-touch thermometer and get the leaf temp, not the air temp.Led grow, temo is 80-82 humidity 60-70% strange uh it in range I think for the led temps