ken dog
- 1,699
- 263
I drilled a 1 1/2 " hole in the bottom of a 7 gallon bucket and installed a flood table bulkhead... so that I could run the exit hose of the water chiller, directly into the bucket.
Then I drilled one at the top, just below the bottom of the net pot, so the water could overflow and exit the bucket.
Then I took out a 1 inch section out of the bottom of the net pot, so that I could put the 2 foot long tail of a two-week old clone, through the bottom of the net pot, so that it would be submerged in the nutrient solution.
Then I ran two air hoses down through the top of the net pot, connected the air stones and put them in the bottom of the bucket.
then I inserted the clone, and filled the 10 inch net pot with hydroton.
Then I put the whole thing inside of a 20 gallon reservoir... dropped in a submersible pump, and connected it to the intake of the water chiller.
then I added two more air stones to the res.
Then I drilled one at the top, just below the bottom of the net pot, so the water could overflow and exit the bucket.
Then I took out a 1 inch section out of the bottom of the net pot, so that I could put the 2 foot long tail of a two-week old clone, through the bottom of the net pot, so that it would be submerged in the nutrient solution.
Then I ran two air hoses down through the top of the net pot, connected the air stones and put them in the bottom of the bucket.
then I inserted the clone, and filled the 10 inch net pot with hydroton.
Then I put the whole thing inside of a 20 gallon reservoir... dropped in a submersible pump, and connected it to the intake of the water chiller.
then I added two more air stones to the res.