Are you going to share how YOU get from a cutting up to this point?
I have tried cloning in blocks and rapid rooters with 0 success. I have almost 100% in an aero cloner and I get really nice roots but your roots put mine to shame lol
Shamrock, what works for me when rooting in rockwool and Rapid Rooters, Precondition your Rockwool with something like this:
http://www.growsmarthydroponics.com...dftrk=gdfV22646_a_7c984_a_7c3687_a_7cHDROCGAL
Per gallon I also add 1ml Roots Accelerator, 2.5ml
Calmg,2.5ml MAd Farmer Nuts and 2.5ml B1
Ph the nutrients to 5.6 and soak the Rockwool for about 30 minutes. Pour off exess Nutrients.
I cut clone off with scissors then razor blade a 45 degree cut on a flat surface.
Set cutting in your clone gel. I cut 6 then plant the 6, not sure if it makes a difference allowing them to sit in the gel a little longer, but it is convienient.
Mist top cover with water on inside. Put on the cover and duct tape around the edge to make a good seal. I also wet a sponge or paper towel and set it on top of the air vents on top of cover. Do not place on concrete floor, the cooler it is, the slower it will root.
After 4 days, I open it, foliar with Dutch Masters 15ml Maxfx and 15ml Folitech Grow and 1ml
Calmg.
Retape the cover for 3 more days then open and feed with 30ml
Clonex, 2.5ml
Calmg, 2.5ml B1, 1ml Roots Accelerator
Put cover back on, but do not retape.
Same process for rapid rooters, but no rockwool preconditioner.
This works 100% of the time, clones never yellow and you don't need to trim off as many leaves. I allow 2 fan leaves on each clone. Hope that helps.