PPM is new to me. Know what it is but not exactly why we use it. Tested my tap water and it’s about 120ppm of I recall.
Feeding was yesterday and 3(?) days ago. Both times it was 10ml/cc FFGB & epsom. PH 6.3. Both times to run off. It was
not fed or watered today. Was just going to water tomorrow @ PH 6+ nothing else. Unless directed otherwise.
Okay...not having read about this let me see if I know off the top of my head.
Didn’t know I could use FFGB as foliar. No burn or only just before lights out? I’m doing 6/2x3 for light cycle.
So base would be my water source after sitting 24hr which is approximately 120ppm & PH 7.5. So I would then add FFGB until 270ppm? (No idea how much that would be at the moment.)
Based on my above answer I’ll do so.
Here is a pic up close of the new leaves.
View attachment 1319196
At least slowed it way down. Can’t be 100% sure. To many yellow leaves to keep track. Cut a few more off tonight. Dozen every few days.
Clawing improved when I moved the fan up a bit and after her second feeding. Now it’s maybe droopy in areas.
Light was at 75% last 24hr and back to 50% tonight. Looking to see if yellow reoccurred. Don’t believe so but back to 50% to slow growth until fixed.
Sounds good. Two waterings at approximately 3L each, 10 minutes between each litre. If runoff occurs I’ll note and adjust for nex time.
Am I doing feed, 2 days later water, 2 days later feed, etc.? PH 6.
I hear you. The saucer is 20” & elevator is 18.5”. That’s 95L...
My soft pot is currently 16” diameter, not including bulge. So I can go a few inches larger. It looks like I have access to a 20G soft pot that’s 20” diameter for $15. Or 25G unknown diameter for $13 at different store.
Besides removing the scrog without damaging the plant I also have limited work space. A basement freezer is my usual table top. I wait until plants need water before transplanting so it’s easier and lighter.
Let me see what I’m able to do tomorrow.
If you need more/better answers let me know.