Looks like you are moving right along buddy! 3 Styles at once? Badass!
Look at you, I didn't know you had some McGyver in you. Get down!
Looking forward to your feedback on the outcome at the finish line.
-TF
Hahaa! I loved watching MacGyver as a kid... Hey I may just be a Construction Manager, but I do know how to use power tools... Nevertheless, the Water Weld didn't work well as I should have sealed the crack on the inside of the bucket... Thx for cruising through TrichromeFan!
Nicely done with the JB weld action. I'm interested in seeing how well that works out over the course of the run.
I think your girls could benefit from some topfeeding, it helped mine when they looked like that. I would also run the RH up to 60-70% and see how they respond. Of course, about a week after they take off, you'll need to take the humidifier out and put in a DE-humidifier, lol, but that's the kind of problem you want to have, right?
Some 'light' reading on bulb life issues with dimming::cool:
Thx bro, I think the Water Weld would work if I had sealed both sides. Also, I will need to get a humidifier to raised the 10'x10' room's RH... Got any suggestions of good brands for that size room?
Nice work Shady!
Your rooms always look so neat and tidy.
You might try raising the humidity a bit and maybe reducing the airflow on the affected plants slightly.
Good luck homie!
Thx for the props and advice waayne!
What he said ^^^.
Thanks for the tip on that album- I like.
PB
Word up PB!
Call UC and your new buckets should be there in a few days No charge. I had one crack like that also, same spot.
No doubt eh! UC customer service is hands down one of the best around...
The leaves curl down with too much N, they curl up when RH is too low.
Very true...
A Big Thanks to Current Culture...
Once again, a big thanks to Dan and the folks at
Current Culture! You guys are solid, stand behind your product, and truly care about your customers... No reason to wait and switch out the bucket when the replacements were here in a day, so I pulled out the beat up cuts and set them under the 600W HPS dimmed to 360W. I'll hand water until they snap out of it, but I will need to get a humidifier to raise the room's RH...
Then I emptied the system, carefully pulled out the bucket, and took the opportunity to tightened all air and water lines...
I also cleaned out the in-line filter which had a couple hydroton fragments slowing down the flow...
Got the new bucket with a clean
Current Culture logo in place and ready to rock...
Also got a few cuts ready to roll as a backup plan...
:cool: