This mornings pic:
View attachment 1303287
Quite a few tops are now through the second netting, and aside from some leaf tucking and top training where applicable, nothing else has changed.
The lights have been on 100% for the last week and I’m not seeing any light stress. The lights are also pretty high up, maybe another inch or so from being maxed out. There’s still a 22-26” distance from the canopy to the light, so I think that’s all good and doesn’t need any further adjustment.
The lower plant felt light, so I used my soil tester and was “dry+” throughout in the few test spots I put it in. The top plant still has some weight and is reading “normal” once the probe goes halfway down.
I fed the bottom plant just a few minutes ago - about a gallon, and I have another gallon ready to go for the top plant. I’ll test it again throughout the day, and if I have to wait until tomorrow, no biggie.
I did change around my humidity sensor and humidity settings a smidge. The outlet that’s controlled by the humidity sensor is now about halfway up the tent, and kicks on between 45% and 51%. I had it at 48% to 55%, but with the colder temps coming in, and having to have my pellet stove going, the humidity in the basement drops to less than 30%.
I was able to raise it to 34% before I went to bed using a few damp towels in front of the stoves blower and another small humidifier halfway across the basement.
The reason I adjusted the sensor and settings is so that I wouldn’t run out of water in my tent humidifier while I’m sleeping as it was just constantly running trying to reach 55% that it likely won’t hit during the winter.
That’s all for now :)