M
montroller
- 19
- 3
I just use the sun for vac during the summer and reptile heat lamps during the winter. Depending on the strain I try to keep it at 130-140 in vac to get a hard shatter or honeycomb otherwise most runs will stay sappy for me.
As far as time goes there is no way to set a specific time because it varies so much by amount, surface area, strain, actual vacuum level, and heat. The best way is to just stay close by and check every 15 minutes to half hour until it is where you want it.
Even shatter can turn to budder if left in a vac with heat for too long so if you don't want budder pull it when the bubbles first stop forming and let it stabilize at room temp to check if it is the consistency you want.
Obviously always lighter test your shit, I had some grandaddy that vacced for 3 days under sunlight and was still in need of a purge so this shit can be very strain dependent.
As far as time goes there is no way to set a specific time because it varies so much by amount, surface area, strain, actual vacuum level, and heat. The best way is to just stay close by and check every 15 minutes to half hour until it is where you want it.
Even shatter can turn to budder if left in a vac with heat for too long so if you don't want budder pull it when the bubbles first stop forming and let it stabilize at room temp to check if it is the consistency you want.
Obviously always lighter test your shit, I had some grandaddy that vacced for 3 days under sunlight and was still in need of a purge so this shit can be very strain dependent.