B
blactunda
- Posts
- 91
- Reactions
- 69
- Joined
- Nov 7, 2016
- Points
- 18
Anyone rocking version 2 of the spydrx?
Not yet, I will be thoughAnyone rocking version 2 of the spydrx?
in order to run co2 does your RH have to be above 50%?If you'e doing the plus you need co2. It' so much light the plant can't take it in unless co2 is high
It looks great. But why the light is so expensive? I can buy almost 4 pcs affordable Mars SP250 that i was using.Good model, we like it,, but just too expensive. We produce similiar models, with Samsung chip, LM301B, meanwell driver. high end, instagram: seegree.growlight
is it absolutely necessary to run CO2? i dont really like running warm daytime temps to accomodate CO2. Was planning on running the Spydr 2p.Different arrangements and setup. The new lights are a little but more efficient over the older ones. For instance the 2p is tops and run less watts than the plus
Yes, co2 is needed to utilize all the light being put off. Otherwise it will beat them up with stress.is it absolutely necessary to run CO2? i dont really like running warm daytime temps to accomodate CO2. Was planning on running the Spydr 2p.
Do you run 4000k in veg and 3000k flower?I run the spydrx in veg and spydrx plus in flower 100% all the time
Do you happen to know who's/what model chip they use for the LED? Im trying to find itVeg is more 6400k. The spydrx runs all spectrum needed
I have to assume its a samsung chip.Veg is more 6400k. The spydrx runs all spectrum needed
You get what you pay for. I would just do a quantum board setup if that's the caseI have to assume its a samsung chip.
Im considering a QB288 build but I am honestly considering Alibaba. I have seen some on there that replicate the spydr system, they claim in the description top shelf components but lets be honest it is alibaba.
I agree, and save a lot of $$ also.You get what you pay for. I would just do a quantum board setup if that's the case
Can anyone give me some ideas as to what I need to change with my setup? I have 2 spydr x plus leds about 3 feet from plants and lights are dimmed to 25% tried going up to 30% and burned the tops. I turned co2 up to 1200 which helped alot but im wondering why my plants are so fragile/ burn so easily. CO2 is set to 1200 and room temp is at 86 degrees. Any clue where I might be going wrong?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?