Just Put my clones that had decent Roots into my deep water system weighted about 2 weeks they've been progressively getting worse with no roots popping out so I pulled out the worst one and this is what I found.
Starting week 6 and I am getting some clawing leaves at the top and some rust on the lower part of the plants. my ppms with a 500 scale is at 660 in a under current and the pH is dropping.
Here is what's up my EC was high around 600 ppms on a 500 scale I noticed that my pH was dropping and my ec was going up so I dropped the EC to 350 but still the EC would rises. So I dropped it again to 220 ppm with only uc roots and h2o2 29% at 3ml a gallon and still the same thing. I have no...
week 1-cloning
week 2-They are in veg light is on a light rail and its a 600w its a twelve site UC that I built my self.the air pump is a 110L so i should be good there. I made my chiller out of a dehumidifier 26 pint works great keeps water at a range of 62-68.I just put the clones in the UC.
Has anyone used this company of leading lights? They seem to be some of the cheapest leds around. I want to use the 180x3w panel for every two plants in a 8 site under current. right know I am running 4 600 watts over them would 4 180x3w panels be able to replace them.
Here is a link to site...
Yesterday ph in uc was 6 today 5.8 ppm dropped very little but shouldnt ph go up when ppm are being taken up? I am using cultured solutions water temp stays around 65 water level didnt move much week three of veg.
just started to see it around air stone what can i use to get rid of it wILL PHYSAN 20 WORK AND AT WHAT ML PER GALLON?
Can I Run it With Plants in system?
starting a 8 site UC right know with ice in 2-liters i can keep it at 68 could this product work for smaller UC?
link to manual
http://www.novatecproducts.com/IPAC-50Manual10-28-03.pdf