ttystikk
- 6,892
- 313
@ttystikk
My EC is:
1.50 ttp
1500 ppm
3.05 ms
Those are all the same I think :) Just different units of messure.
Ok, I added another vortex fan. I now have one blowing air out the chimney, and one taking air in from the basement. I opend two windows in the basement, so there should be plenty of fresh air, and hopefully it won't get too cold. Or at least not as cold as if taken directly from the outside.
I also added a 120w dehumidifier I just rememberd having (shut up) and hopefully that will help. Now I just hope I don't blow a fuse (again..)
The humidity fell to 76% about 5-10 min after those changes.
Edit: humidity at 72% after a few hours. I have set the intake fan to turn off with the lights, hopeing it wont get too cold at night.
Very very helpful. Thank you.
I will keep a close eye on the temperture. Where should I messeure it? Under the plants and not in direct light, or what?
I will buy a hepa filter for my intakt fan asap.
I will flush the system with clean RO water and add a less concentrated feed.
@ mr cheese
Thank you. That is real helpfull. I have been adding equal amounts of micro / bloom / grow because that was what the bottle told me to do. I will definitely change that. I am also starting to think that the amount's recomended on the bottle is for growing with no other additives than micro / grow / bloom, so if I follow them and then add BigBud and Sensizym and CalMag, my EC will explode. They are running on tap water now (did since yesterday) and I will flush them with clean RO water today, and then change that for RO with a light nutrient mix (without Grow and CalMag)Sounds like a good plan right?
Ps. Should I still add BigBud and SensiZym?
I have adjusted the EC to .70 MS. I will measure it again tomorrow to see if it's going up or down, and act accordingly.
I have managed to raise the temperature in the room to 25c but that makes my water in the system 24c as well, and I think that is too high (right?). I have dumped a 1½ liter bottle of frozen water in the reservoir to lower it a bit.
My PH is up to 6.5 but as I understand I should not adjust it while it's in 5.5 to 6.5 range.
Some pics from today. Some of them surely looks better than others. The last 2 pictures are from my old mother plant that I am flowing along side the Aeroflo.
My EC fell from .7 to .63 over 24h so I added some more nutrients.
I adjusted the EC to 1.06 ms and the PH is back at 5.5.
Water temperature is 72f (25c) now, but I will buy some 5 liter bottles and chuck in the freezer, and then the reservoir, to lower the temperature.
I may buy a water chiller when I get some more cash flow.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?