F
frostedlove
- 687
- 0
unless you already have PM high humidty is not your enemy
buds molding from 85% is though
Looking good frosty!
Good idea to make sure there is enough airflow. Warmer temps will help to keep the rh down but I imagine it can't be avoided with in/out air and the fog.
sealed with c02 would be good, but then will need to run a ac and so the cost rises. (c02/ac power requirements) will give you more control over the humidity your bringing in.
not sure if it is possible or you have the room. Another option, use the dehury to warm and dry the cold air in a outside area, before bringing into your tent.
can blast the dehuey at lights off to help keep it warm can then cycle in/out air. I find keeping it warmer helps with the higher rh at night.
hot air coming off the dehuey can create a hot spot so I find it is a good idea to circulate the hot exhuast air of the dehuey with fan.
I recall you having a digital thermometer??, break that out can scan around the tent and see how consistent temps are. cold areas are where excessive humidity can hide. (like the root zone) heat rises, cold falls so sometimes fans pointing up can balance out temps/rh.
Hope that helps
ME and MY family would like to thank you fellow farmers out there for all your help in making our FAMILY GARDEN a success. We could not have done it without you guys! Grandma is doing better these days, she sleeps longer and better at night due to tintures and her vaporizer. This will he our first real harvest and I am so excited to be able to provide grandma with enough meds, she can now comsume as much as she needs with little mind or thought to how much it all cost. She would short change herself on the tinture because of the cost and how often she would run out.
Grandma's life is improving as well, she is now going to the Senor center in town and spends 3-4 hours there a few days a week. All atribuited to her meds. and now the list of pills she has to take is down! THANKS MMJ
May ALL your harvest in the new year be GREEN and STICKY! We send our love and thanks to all you out there......
Happy Holidays brah! How about some full plant shots and more info on your nutrient mix? RO water and CalMag stats... Including final pH and PPM's would be helpful... Sometimes this can occur from root bound and spinout conditions, so info on your pot size and last transplant would be nice to know as well... :thinkingSO ANY GUESSES AS TO MY NEW PROBLEM
not on all leaves not on all plants.....more on ogs'
should we flush??????
when indout flush is what I am always told
could be the bloomblastic but I did not add tons and the ppms were still low
?????
any guesses masters
maybe cal/mag defic
:whew motherlode's on point as usual... Ditto on the CalMag dose for the OG's... The pH of the runoff isn't as important as the pH of your nutrient mix so keep that consistent and let us know what pH your mix is set at... Also if the PPM's you mentioned are based on a 0.5 conversion to EC, then I'd be a bit higher in bloom, but let's see some more Picts tomorrow and note the day of bloom that your girls are currently in... :thinking
bump your cal mag to 6 ml next feed and then go with 4 ml
ogs love cal mag and rusty spots like that usually go away after you bump it up
lots of time this shows up around the end of the stretch 2-4 weeks into flower
are those leaves from the lower part of the plant that dont get much light as well?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?