Log In Register

Iso/everclear Slab... No Butane.

  • Thread starter Thread starter GT21
  • Start date Start date
  • Tagged users Tagged users None

Iso/everclear Slab... No Butane.

GT21 1,718 Replies 210,045 Views
Page 14 of 86 · Replies 261–280 of 1,719
Status
Not open for further replies.
I have run 91 and 99% ISO, and you can achieve the same results with both. I have found that when running the 91%, cook time is a little longer, and the time you spend whipping at the end of the cook is also longer. It's also worth noting that most pyrex dishes have convex bottoms, so you need to make sure you are moving the product from the edges into the middle to get a consistent cook across your product, and don't end up with a thick syrup or wax consistency for the end product. If it's not hard to scrape out of the pyrex at the end of your cook....then keep on cooking. That said, I am far from an expert in this area, so take this for what it's worth.
 
Heres my new thing, dry ic sift into oil by rosin pressing....solventless extration...super clean meds
 

Attachments

  • image.jpeg
    image.jpeg
    102.9 KB · Views: 333
  • image.jpeg
    image.jpeg
    112 KB · Views: 320
Oh nice!!... ya the old hps/mh mix been around since growing with lights. How much do your bulbs cost?

Yea it's been around for awhile but I'm not complaining lol. My bulbs are 50 a piece but I usually pick up a pack of 4 at a time so they are a lil cheaper.
 
Yea it's been around for awhile but I'm not complaining lol. My bulbs are 50 a piece but I usually pick up a pack of 4 at a time so they are a lil cheaper.
Nothing wrong with a product like that. I just use a 20 dollar Ipower and a 20 dollar uv bulb.... but as long as you get good product. ..well then CHEERS!!!!
 

Attachments

  • 2016-01-29 20.49.42.png
    2016-01-29 20.49.42.png
    241.9 KB · Views: 329
  • 2016-01-29 20.50.15.png
    2016-01-29 20.50.15.png
    220.8 KB · Views: 322
3 1K's 2 HPS, and one MH. HPS are rated at 2200k and MH is 5k.
man have you seen LEC? My 315LEC are 700 and my MH only 500 and 20% more power.
Arguably the most important attribute of any bulb is its yield per watt. Yield per watt is a measurement of efficiency. Traditional 1000 watt HPS bulbs are generally considered extremely efficient if you’re getting anywhere near 1 gram of produce yield per watt of light used – or 1000 grams from a 1000 watts – this is just over 2lbs per light. With the LEC 315 I’ve seen some people be able to pull down 450-500 grams per 315 watts. That’s 1.4-1.5 per watt! If you had 3 LEC’s putting off almost 1000 watts you may be close to 1400 grams per 1000 watts. The yield per watt alone makes this system extremely efficient and cost effective.
peace eco
 
Status
Not open for further replies.
Page 14 of 86 · Replies 261–280 of 1,719
Back
Top Bottom